Steps for commissioning Belt Conveyors and safe operation procedures for belt conveyors
(1) After the installation of each equipment, carefully adjust the Belt Conveyor to meet the requirements of the drawings.
(2) Each gear unit and moving parts are filled with the corresponding lubricating oil.
(3) After the belt conveyor is installed, each single equipment is manually tested, and the belt conveyor is combined to meet the requirements of the operation.
(4) Debug the electrical part of the belt conveyor. Including the debugging of conventional electrical wiring and actions, so that the equipment has good performance and achieves the designed function and state.
Belt conveyor safety operation procedures
1. Dress neatly and hold a valid certificate.
2. Implement the relevant provisions of the Safety Regulations for Coal Preparation Plants.
3. The driver must clear the signal and start and stop the conveyor according to the specified signal. Before starting the machine, check that all kinds of connecting fasteners and safety facilities are complete and secure.
4. Always pay attention to belt running when the conveyor is running. It is found that the belt is deviated, the card is scratched, the joint is seriously damaged, and when the temperature and sound of the roller, roller and electrical machinery are abnormal, it is necessary to stop immediately and report to the professional for processing, and then continue to start after processing.
5. Operate the spray switch depending on the degree of dryness of the coal to carry out spray dust reduction.
6. When slipping or suffocating the car occurs, it is necessary to find out the reasons for proper handling.
7. When handling the chute blockage, the system of stopping the power transmission must be implemented according to the relevant regulations of the coal preparation plant, and special personnel should be used for monitoring and single operation is prohibited.
8. When handling deviation, it is strictly forbidden to directly touch the Conveyor Belt with hands, feet and other parts of the body.
9, the class often cleans up the equipment and environmental sanitation, to achieve a clean environment. It is forbidden to clear the goods in or near the rotating parts or to work in the belt conveyor.
10. Talk to the successor of the operation and precautions of the equipment of this class, and make a record of the position.
