Operation instructions and maintenance methods of the
Assembly Line are as follows:
1. Brief operation of electrical equipment
The power supply of the assembly line needs three-phase four wire, and there is a main switch outside. (you can use three-phase four wire four pole switch, or you can use the switch to control only three-phase power supply, and the zero wire is direct. Pay attention not to pass the zero wire of the second connection method through another switch).
2. Method of starting motor:
Connect the power supply first, and then all three power indicator lights will be on, proving that the three-phase power supply has reached the distribution box. At this time, you can press the blue button on the motor to start the motor. If you can't start it, you can open the door of the distribution box to see if the second dz108 switch in the first row is long in red and short in blue. If you don't press the blue one down. After the motor is started, turn on the switch of the pipeline speed regulator, and then slowly raise the potentiometer of the speed regulator to the desired speed. When shutting down, first slowly lower the potentiometer of the speedometer to zero, then turn off the switch of the speedometer, and then press the red button of the electric mechanism once to stop the motor. Finally, turn off the main switch.
3. Fluorescent lamp start
Press the blue button of lighting to start the fluorescent lamp, and then press the red button of lighting to turn off the fluorescent lamp. If the fluorescent lamp does not light up, please check whether the flat switch on the fluorescent lamp bracket is in the position of 1. Finally, check whether the third and fourth DZ47 in the first row are in the open position.
The maintenance methods are as follows:
1. Maintenance and repair methods of head motor:
Do not water the motor, or add diesel oil and liquid organic compounds to the motor, as this may cause damage to the insulation of the motor and cause failure. The maintenance method of the governor head is the same as that of the motor. Check the motor maintenance and repair in the electrician's manual.
2. Chain maintenance:
After long-term operation of the chain, the original lubricating oil may be heated and volatilized, resulting in unbalance, noise increase, crawling, etc. At this time, the sealing plate at the tail of the machine can be opened, and the chain can be added with butter or a little thick lubricating oil. 3. Maintenance and repair methods of the reducer at the head of the assembly line:
For the first time, drain the engine oil in the gearbox in about three months, clean the gearbox with diesel or gasoline, and then add new lubricating oil to the middle of the observation window. (pay attention to the lack of lubrication every month). In the future, you can change the lubricating oil once a year. Too much lubricating oil may cause the gearbox to heat up and the motor overload may cause the motor protection switch to trip. Too little lubricating oil may cause gearbox heating, noise increase and gearbox strangulation.
http://www.conveyortop.com